PROGRESS IS OUR COMMITMENT
THE EARTH OUR CONCERN


CRC Industries Europe bvba
Touwslagerstraat 1
9240 Zele - Belgium
Tel (+32) (0) 52 / 45 60 11 - Fax (+32) (0) 52 / 45 00 34

Material Safety Data Sheet Regulation EC No 1907/2006 Art.31

Productname : SUPERCUT Creationdate : 31.10.07
Ref.Nr.: AB14750-3-311007 Replaces: 30.01.06

1. IDENTIFICATION OF PRODUCT AND COMPANY   

 

Productname : SUPERCUT
Aerosol

 

Application :

Lubricants
High performance cutting oil

 

Company :

CRC Industries Europe bvba
Touwslagerstraat 1
9240 ZELE
Belgium
Tel.: (+32)(0)52/456011
Fax: (+32)(0)52/450034
E-mail : hse@crcind.com
 
In case of emergency : (+32) (0)52/45 60 11
 

Subsidiaries

 

Tel

Fax

CRC Industries Finland

Asemanrinne 13, 08500 Lohja AS

(+358)(0)19/32921

(+358)(0)19/383676

CRC Industries France

12, Bld des Martyrs de Chateaubriant F-95102 Argenteuil Cédex

(+33)(0)1/34112000

(+33)(0)1/34110996

CRC Industries Deutschland

Südring 9, 76473 Iffezheim

(+49)(0)7229/3030

(+49)(0)7229/303266

CRC Industries Iberia

Gremio del cuero S/N, 40195 Segovia

(+34)921/427546

(+34)921/436270

CRC Industries Sweden

Kryptongatan 14, 43153 Mölndal

(+46)(0)31/7068480

(+46)(0)31/273991

2. HAZARD IDENTIFICATION   

Health and Safety :

According to EU-directive 99/45/EC not classified

Environment :

According to EU-directive 99/45/EC not classified

Other hazards :

Pressurized container : protect from sunlight and do not expose to temperatures exceeding 50°C.

3. COMPOSITION AND INFORMATION ON COMPONENTS   

Hazardous ingredientCAS-nrEINECSw/w %symbolR-phrases*Notes
carbon dioxide124-38-9204-696-90-1--A,G
Benzenepropanoic acid, 4-hydroxy-501-97-3207-931-3<0.25NR51/53
polysulfides, di-tert-dodecyl68425-15-0270-335-7<2.553
zinc alkyl dithiophosphate 68649-42-3272-028-3<0.5N,XiR38,R41,R51/53
tetrafluoroethane811-97-2212-377-05-10--B
mineral oil (IP 346 DMSO extract < 3%) not available265-098-160-100--B
2-ethylhexylzincdithiophosphateN0137<1.5NR51/53
Explanation notes
A : substance with Community workplace exposure limit
B : substance with national established workplace exposure limit
G : excempted from the obligation to register in accordance with art.2(7)(a)of REACH Regulation No 1907/2006
Note H and L of Annex I (67/548/EEC) apply for complex oil derived substances in this product.

4. FIRST AID MEASURES   

General Advice :

The usual precautions for handling chemicals should be observed
If any symptoms should occur, seek medical advice.

Contact with eyes :

If substance has got into eyes, immediately wash out with plenty of water

Contact with skin :

Wash with water and soap.

Inhalation :

Fresh air, keep warm and at rest.

Ingestion :

Ingestion is unlikely to occur
If swallowed do not induce vomiting
Seek medical advice

5. FIRE-FIGHTING MEASURES   

Flash point (without propellant):

195 °C (Open Cup)

Explosion limits : upper limit :

not available

lower limit :

not available

Extinguishing media :

foam, carbon dioxide or dry agent

Fire-fighting procedures :

Keep container(s) exposed to fire cool, by spraying with water

Unusual exposure hazard :

Aerosols may explode if heated above 50°C

6. ACCIDENTAL RELEASE MEASURES   

Personal precautions :

No special requirements.

Environmental precautions :

Do not allow to enter public sewers and watercourses

Cleaning methods :

Absorb spillage in suitable inert material

7. HANDLING AND STORAGE    

Handling procedures :

The usual precautions for handling chemicals should be observed
Do not spray on a naked flame or incandescent material.
Do not pierce or burn aerosols, even after use.

Storage procedures :

Pressurized container : protect from sunlight and do not expose to temperatures exceeding 50°C.
Keep in a cool, dry, well ventilated place
Keep out of reach of children.

8. EXPOSURE CONTROL AND PERSONAL PROTECTION   

Control procedures :

Ensure adequate ventilation

Personal protection :

The usual precautions for handling chemicals should be observed

inhalation :

Use only in well ventilated areas
Wear approved respirator if exposure likely to exceed MEL/OES

Exposure limits :

Hazardous ingredientCAS-nrmethod
EU established exposure limits:
carbon dioxide124-38-9TWA5000 ppm

9. PHYSICAL AND CHEMICAL PROPERTIES (for aerosols without propellant)   

Apperance : physical state :

Liquid under pressure

colour :

amber

odour :

oil

Melting point/range :

not available

Boiling point/range :

not available

Relative density :

0.88 g/cm3 (@ 20°C)

pH :

not applicable

Vapour pressure :

not available

Vapour pressure :

not applicable

Relative vapour density :

not available

Solubility in water :

Insoluble in water

Partition coefficient n-octanol/water:

not available

Flash point :

195 °C (Open Cup)

Auto-ignition :

> 200 °C

Viscosity :

20 mm²/s (@ 40°C)

Evaporation rate :

not applicable

10. STABILITY AND REACTIVITY   

Conditions to be avoided :

Pressurized container : protect from sunlight and do not expose to temperatures exceeding 50°C.

Materials to be avoided :

Strong oxidising agent

Hazardous decomposition compounds :

CO,CO2

11. TOXICOLOGICAL INFORMATION   

Other information:

No experimental data available

12. ECOLOGICAL INFORMATION   

Do not allow to enter public sewers and watercourses

13. WASTE DISPOSAL   

Product :

Do not empty into drains.

Disposal should be in accordance with local, state or national legislation

14. TRANSPORT   

UN-number :

1950

Road/Rail - ADR/RID :

UN1950 Aerosols Class : 2, PG : NA, Class code : 5A, Label : 2.2

Sea - IMDG :

UN1950 Aerosols Ltd Qty Class : 2.2, PG : NA
 

EmS

F-D,S-U

Air - IATA/ICAO :

UN1950 Aerosols, non-flammable Class : 2.2, PG : NA, Label : RNG
 

Packing instr. LQ

Y203
 

PAX

203
 

CAO

203

Remark: data valid for original packaging

15. REGULATORY INFORMATION   

Pressurised container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do not pierce or burn, even after use. Do not spray on a naked flame or any incandescent material.
According to EU-directive 99/45/EC not classified

16. OTHER INFORMATION   

This product should be stored, handled and used in accordance with good industrial hygiene practices and in conformity with any legal regulation.
The information contained herewith is based on the present state of our knowledge and is intended to describe our products from the point of view of safety requirements. It does not guarantee any specific properties.
Apart from any fair dealing for purposes of study, research and review of health, safety and environmental risks, no part of these documents may be reproduced by any process without written permission from CRC.

 

This Material Safety Data Sheet may already have been revised at this moment for reason such as legislation, availability of components and newly acquired experiences. The latest and only valid version of this Material Safety Data Sheet will be sent to you upon simple request or can be found on our website : www.crcind.com. We recommend you to register on this website for this product so you will be able to receive any future updated version automatically.